Start
with the right side by removing the battery. Be sure to write
down your radio presets as they will be lost. |
|
|
Using
a 11mm or 7/16" deepsocket remove the two nuts holding
the lenses in place along with the two screws on top. Be careful
to not pull out the wiring for the lights themselves. |
Pull
off the assembly, if your inclined to then clean the chrome
bezel around the light. |
|
|
Remove
the stablizer bracket from the upper lens and slide it off the
corner lens. Unscrew the lens from the bezel. |
|
The
new lenses will likely come with some standard style nuts on
them, I suggest using the original flare-nuts instead of the
new hardware. |
|
Attach
the corner light to the bezel, reinstall the stablizer bracket,
and install the assembly into your truck. Plug in the bulbs
and you're set. Go onto the left side |
|
Remove
the windshield washer/radiator overflow tank and set it on top
of the air cleaner. Keep in mind the washer fluid line is directly
underneith the tank. |
This
is optional but makes things a LOT easier, on 93-96 Broncos
you will find the ABS computer under the coolant tank. Disconnect
the plug from it,remove the 10mm bolt holding it in and slide
it out of the keyway (see lower image) |
|
|
Remove
and install the left corner light just as the you did for the
right. Installation is exactly the same. Test your lights and
turn signals, make sure everything got plugged in properly and
your directionals work properly. |
|
You
now have your clear corners installed, enjoy your Bronco's new
look! |